LPG nozzle: critical for safe, efficient transfer of liquefied petroleum gas via sealed connections.
 

ABAHTECH Internal Threaded Rear Sprinkler Head

The new tees are designed for maximum strength and are close in weight to aluminum tees, unlike the competitors’ porous inlet castings.
Available in 5” and 6” straight or bottom drop configurations, product is pushed out of the tank by tank pressure and pulled from the tank by line pressure. The unique groove design creates a venturi effect that “pulls” product out of the hopper, allowing product to be unloaded faster than any tee on the market.

LPG nozzle is a device for transferring liquefied petroleum gas, used in refueling or industrial filling. It features safe valves, precise flow control, and compatibility with LPG storage systems.

Features and Benefits:
Coil Spring – Tested to provide over twice the cycling life as a conventional torsion spring.
Spring Housing – Protects your load from being contaminated from a broken spring.
Fewer Internal Parts – Fewer parts means lighter weight and less risk of contamination.
Bell Housing Design – Provides more open area which results in less back pressure.
Guide Bushings – Bushing stops poppet from opening too far and choking flow or damaging spring.
Flat face poppet Valve – No fasteners allows more surface area for flow and less back pressure. Self-sealing gasket design.
Available in 3 or 4 inch sizes.

Type:tanker trailer emergency shut-off valve
Material:stainless steel
Temperature of Media:low temperature
Power:pneumatic
Media:fuel,chemical,water etc
Structure:shutoff
Standard or Nonstandard:standard
Max air flow rate:2500L/min
Work pressure:0.6MPa
Temperature:-20℃~+70℃